2018151_d•en•2019-10-01
We reserve the right to make technical changes
6
Button/
display
Cction/result
+
Select the channel on the WMS Wall-
mounted transmitter plus (2) using the
+
button.
IUTCCE
O
If an unassigned channel is
selected, press the
+
button for
5 s. As soon as the LED flashes,
all channels can be selected by
pressing the
+
button again.
Briefly press the learn button on the TAR-
GET TRANSMITTER (WMS Wall-mounted
transmitter plus 2).
L LED lights up green.
The transmission LED
on the WMS
Wall-mounted transmitter plus (1) flashes.
GRCECEO
During the transmission of data from the
WMS Wall-mounted transmitter plus (1) to
the WMS Wall-mounted transmitter plus
(2); this ends with
GRCECEO
Lights up continuously for 2 seconds,
transmission successful
RCED
Lights up continuously for 2 seconds, error
during transmission
The L LED
on the WMS Wall-mounted
transmitter plus (1) and (2) goes out.
CExample 4:
Uhe existing unit with a WMS Wall-mounted
transmitter plus is expanded to include a WMS
Hand-held transmitter comfort
Step 1:
Cdd the WMS Hand-held transmitter to the existing net-
work with a WMS Wall-mounted transmitter plus
Button/
display
Cction/result
Wake up the WMS Wall-mounted transmit-
ter plus with the STOP button
.
Wake up the WMS Hand-held transmitter
comfort with any product button.
Press the learn button on the WMS Wall-
mounted transmitter plus for approx. 5
seconds.
+
lights up green; the transmission LED
flashes. For several seconds, the
(large) WMS Hand-held transmitter scans
the operating range for devices.
The WMS Wall-mounted transmitter plus does
not find any device during scanning:
The transmission LED
lights up.
IRCOGCE:
No receiver found.
If the WMS Wall-mounted transmitter plus
finds a receiver, transmitter or sensor that has
not yet been learned in, scanning is stopped.
It is indicated as follows:
The transmission LED
lights up.
RCED:
New device
+
When you press the
+
button briefly, you
can check WHICH target device was just
found.
The product then waves and the control
function LED flashes.
RCED:
The target device (transmitter or sensor)
can be added to the network.
Press the STOP button
.
The found target device (transmitter or
sensor) is added to the network.
The target device waves in confirmation.
Briefly press the learn button
to leave
the learn mode.
You can now add additional scanned products in the
same manner.
Briefly press the learn button to leave the
learn mode.
IUTCCE
O
If the large WMS Hand-held transmitter comfort
is still in its factory state (no products have
been learned in yet), the
lights up in red
after the transmitter wakes up.
