12
REMOTE ELECTRIC OPERATION
To operate the valve remotely the button [2] has to be pressed to get the controller into “remote” position.
The actuator will no longer react to the local controls and is controlled by the signals sent to it via its connection interface.
The precise details of these depend on the configuration of the controller.
COMMISSIONING
The valve with actuator and controller is delivered ready to use with the basic setup already carried out. For more
advised options, including remote control some setup is required. See the specific controller documentation for setup
procedures. The documentation can be found here: https://www.linakthirdparty.com/products/motor-controllers-and-
drivers/wcu/#/brochuresmanualsandbussetupfiles
LOCAL ELECTRIC OPERATION
To use the valve, the controller has to be in the “local operations” mode, activated by pressing the button [2] shown on
the figure below. Note that when in this mode remote controls are inactive and will only be activated by pressing the
[2] again.
To open the valve press and hold the “Up” button [1]. To close the valve, press and hold the “Down” button [3].
The current position of the valve is shown on the display [4], 0% indicates a fully closed valve and 100% indicates fully
open. The valve will automatically stop when it reaches its programmed end stop.
ELECTRIC OPERATION LINAK ACTUATOR, IF SUPPLIED
1
2
3
4
