Instruction Handbook KL
Chapter 9
BA KL V11 en
10/2014
page 9-13
9.5.3
Cardan joint KL 30
– KL 100
Dismounting:
1.
Remove rotor.
2.
Undo and remove both screws 1957 of a side of the joint with an Allen wrench.
3.
Remove washers 1961 and O-rings 1958. (Washers 1961 only to types KL65)
4.
Push out bolt 1959 and pull off joint from drive shaft.
Mounting:
1.
Slide joint onto drive shaft and make sure the bores on joint and drive shaft match.
2.
Insert the connecting bolt 1959.
3.
Connect joint with rotor. Ensure that the connection bores are all in alignment.
4.
Refit all other parts by following the above instructions in reverse order.
Hopper pump
Suction pump
Fig. 9-12
