This is an advanced proprietary algorithm capable of determining the health of a battery. Specially stored
parameters allowing the Analyzer X3 or X6 to identify a battery’s range of capacity and display: Batt>60% or
Batt<60%of rated capacity . Batteries that have a low state of charge when placed in the X3 for the QT
May require a charge of up to 10 minutes before performing the QT. Up to 3 attempts to charge the battery
will be tried before a message is displayed “Discard the Battery”.
Even batteries that do not have pre-stored parameters can have a QT on, but will first be required to go
through the “ Learn Mode”. Note, first a good battery must be learned before QT can be performed .
A impedance test must be performed prior to the “Learn Mode”, and incorporated into the LEARN MODE.
SELECTING “ QUICK TEST “
RESULTS
FOR RESULTS
PUSH
QUICK TEST ANALYSIS
BATT>60% 0R BATT<60%
Display After “Turn On”
After the battery is placed
in the adapter
NO
NO
NO
NO
ACTION
ACTION
ACTION
ACTION
REMOVE BATTERY
PUSH FUNCTION BUTTON
until battery
specs appear
in the display
READY
EMPTY
TO PROCEED PRESS
<FUNCTION>
LION 1650 MAH 7.4V
<FUNCTION> FOR NEXT
LION 1650 MAH 7.4V
HAS BEEN SELECTED
HAS BEEN SELECTED
QUICK TEST
QUICK TEST
TEST
<FUNCTION> FOR NEXT
ACTION
DISPLAY
QUICK TEST ANALYSIS
9
Cycle Mode
The Cycle mode will cycle a battery through a charge and discharge cycle, known as Cycle (1). One could
Select, Cycle 1, 2 or 3. By selecting cycle 1,2 or 3 all one would be doing is repeating the Charge/discharge
number to reflect the chosen Cycle count. Cycle 2 and 3 are often used for incoming quality control of new batteries.
The X3 will display the capacity (in percentage of rated capacity and mAH). It should be noted that after the
FOR RESULTS
Display After “Turn On”
After the battery is placed
in the adapter
PUSH FUNCTION BUTTON
until battery
specs appear
in the display
ACTION
NO ACTION
NO ACTION
NO ACTION
NO ACTION
NO ACTION
NO ACTION
PUSH
PUSH
PUSH
CYCLE/AUTO/CONDITION
<FUNCTION> FOR NEXT
CYCLE/AUTO/CONDITION
HAS NEEN SELECTED
CYCLE 2
CAP=88%
616 MAH
<FUNCTION> FOR NEXT
NICD 700 MAH 7.2V
<FUNCTION> FOR NEXT
QUICK TEST
<FUNCTION> FOR NEXT
HAS BEEN SELECTED
TO PROCEED PRESS
<FUNCTION>
NICD 700 MAH 7.2V
HAS BEEN SELECTED
CYCLE 2
CYCLE 2
TESTING
READY
EMPTY
completion of the Cycle function the battery is left in a fully charged state.
10
SELECTING “ CYCLE 2 “
RESULTS
