64
W&T
If you want to make changes in the device via SNMP (IP address,
subnet mask, etc.) you must first start a session on the device
using your SNMP manager.
m
If you have assigned an administrator password, you must
enter it in your manager software as a „community string“!
Entering the administrator passwortd in the variable
wtWebGraphThermoBaroSessCntrlPassword
opens a session. By reading out the variable
wtWebGraphThermoBaroSessCntrlConfigMode
you can check whether the session was successfully opened.
1
= Session opened, device in configuration mode.
0
= Opening of the session failed. Check whether you entered
the password incorrectly.
After successfully opening the session, you can use the vari-
ables defined in the private MIB to make any configuration
changes.
Once you have finished with configuration, write the variable
wtWebGraphThermoBaroSessCntrlLogout
to close the session.
wtWebGraphThermoBaroSessCntrlLogout =
1
All changes are saved
2
Quit without saving
