WANDERS SOLEA GAS, Users Manual & Installation

Page: 20 / 70

20
Opening the door
2. Removing the clip bindings
from the stovepipe.
3. Lifting the top, and shifting it.
4. Removing the right side cover. 5. Removing the screw of the
lock system.
6. The door can now be opened.
Installation
It is common practice for the dealer where you purchased
your Solea gas fireplace to take also care of installing it
and connecting it to the mains. If this is not the case,
please ensure that the installation is done by a certified
installer. Connecting gas devices by unqualified persons
is prohibited, in which case we cannot give any guarantee
that your Solea gas hearth is functioning properly.
Turning and locking
If you selected the turnable model of the Solea, you can
turn the fireplace and lock it in place at 30 degrees to
the left or to the right. This makes it possible to turn the
flames towards you wherever you are in the room. The
fireplace can only be turned if it is placed straight under
the chimney shaft and stands on a solid floor. You can
lock and unlock the Solea with the knob on the right
hand side in the base of the fireplace (see photograph).
1. The whole Solea.
Putting into operation
When using the Solea for the first time you start as
follows:
1. Open the door of the fireplace (see illustrations on
this page).
You will see the gas control switch in the middle (see
photo).
The gas control switch
2. Preset the O I – switch on mark I.
3. Turn the control switch to the ON position.
4. Then close the door of the Solea and lock it.
Avoid finger marks
Please make sure not to leave any finger marks on
the glass. Finger marks leave stains which burn in
the glass and can not be removed later.