23
GB
WANDERS disclaims responsibility for any cracks in stuccoed walls or discolouration of walls, ceilings and/or
grates after burning the fireplace. Discolouration can be caused when dust particles burn in the convection
cover. To minimize the chance of cracks in stucco and discolouration we refer to the advice given for decorative
hearths. Your installer can give you more information.
Any complaints will be dealt with after the sales firm, the installer has filed a complaint and sent a copy of
the purchase receipt with purchase date. Any repairs do not entitle you to extend the guarantee term. All
consequential damages or loss are excluded.
Installation Instructions Black Diamond and Black Diamond Compact
The Black Diamond is tested in accordance with the international EN 13240 standardization, and has an extra
additional standardization for optimally environment-friendly heating devices related to flue gases (Section
15a B-Vg. Des BmfWA). The stove can be connected to a flue tube to which several stoves are connected. The
flue tube has a diameter of 150 millimetres.
The heating device must be placed by an acknowledged installer and according to the installation
instructions given below. The national and local rules and regulations for placing and using wood-
burning stoves are equally applicable. WANDERS does not give any guarantee if the Black Diamond is
connected or installed incompletely or incorrectly.
It is not allowed to place the stove in:
•
Arcades and corridors accessible to the public.
•
Stairwells, except in buildings with no more than 2 dwellings.
•
Spaces where highly flammable or explosive materials are used.
•
Spaces where an exhaust system is used or where a mechanical exhaust system is placed, except when the
air supply is taken directly from outside to assure a hazardless combustion.
Preparation
The chimney flue
Before placing the stove you must observe the following points:
•
If the stove is connected to an existing chimney, you must first have the chimney professionally cleaned
and checked by a qualified chimney sweep company. Any cut-off valves or stop valves must be removed.
•
The flue tube of the stove must be connected with the chimney without diversions.
•
The underpressure in the chimney must be at least 12 Pa or 0.12 mbar.
•
The chimney flue must always end up in outlet area 1 (see the drawing below)
•
At the time of placing the stove, the chimney flue must be clean, leak-proof and without obstructions, and
!
1
3
3
A X
X > 23˚
3
X
X < 23˚
1
500 mm
