Wamsler N-LINE 111 55, User Instruction

Page: 26 / 92

26
Adjustment:
Table 2
IT IS NOT ALLOWED to burn waste, fine chipping, bark, wood handled with pre-
ventive chemicals, furthermore paper and cardboard. For kindling please use
wood scrapings or grill starter but never use liquid auxiliaries!
The first kindling
•
At the first fire set-up could be a little smoke, but is not dangerous, normal!
In this time, please ventilate the room carefully!
Warning! Upon the first kindling, smoke and unpleasant smell may be gen-
erated. Always ensure the proper ventilation of the room (by opening win-
dows and doors), and heat the fireplace at maximum rated heating perform-
ance. If with the first heating the maximum temperature is not reached, the
above-mentioned effects may as well arise later on.
•
Before installation pull out the delivery securer off the refractory brick through the
furnace chamber (picture no. 6).
Open the door by raising the handle (Picture 2). If the equipment is hot, you can use
insulated gloves. Adjust the primary air regulator and the fuel switch (Picture 3) ac-
cording to the Table 2. Put coal lighter or wood wool onto the fire grate, followed by
wood chips. First insert small pieces of wood, and then larger ones, light them and
close the door again. When the wood burns quickly, and leaves sufficient glowing
embers, put additional fuel on the fire. Thereafter, adjust the primary air regulator and
the fuel switch according to the Table 2 („Adjustment”). The first kindling should be
performed “finely” with little fuel only, so that the parts of the fireplace are adapted to
heat. During the first kindling, the generation of smell is normal and absolutely undan-
gerous.
Fuel
Setting of the
fuel selector “A”
Setting of the primary
air regulator “B”
Warning up,
kindling
OPEN OPEN
Wood
Nominal heating
performance
OPEN CLOSED
Brown-coal
Nominal heating
performance
CLOSED OPEN
Putting out of working
order
CLOSED CLOSED