Wallenstein WX900 Series, Operator'S Manual

Page: 20 / 48

Operating Instructions
WX900 Series
Log Splitter
20
6.2 Before Starting the Engine
1. Check the engine oil level. See page 22.
2. Check the hydraulic fluid level. See page 25.
3. Check the fuel level . See page 24.
4. Check the engine air filter. See page 40.
5. Review the Safety Rules on page 8.
6. Clear the area of bystanders, especially small children.
7. Make sure each operator is trained and familiar with the set
up and operation of the log splitter.
8. Follow the Pre-Operation Checklist.
9. Review the Controls. See page 16 .
10. Survey the work site and place the log splitter in a clear,
level work area.
11. Set up the machine correctly. See page 26 .
6.3 Pre-Start Checklist
Do the following before you start the machine the first time and
every time thereafter:
Items to Complete
Review the Operating Safety on page 19, and Engine
Operation Safety on page 21.
Check the engine oil and fuel levels. If necessary, add
engine oil or fuel.
Make sure that the machine is lubricated as specified in
the Maintenance Schedule on page 35.
Check that the push block or wedge is lubricated.
Check the hydraulic system for leaks. Tighten all leaking
fittings and replace any leaking components.
Remove anything that is entangled on the machine. For
example, branches or vines.
Make sure that all guards and shields are installed, and the
covers are closed. Replace guards, shields, or covers, if
necessary.
Make sure the tires are filled to the specified pressure. For
the correct tire pressure, see the tire sidewall.
Make sure that all of the fasteners are installed and torqued
to the correct specification. For more information, see Bolt
Torque on page 43.
Make sure that the operator and spotter are wearing the
necessary PPE. The PPE must be in good condition.
Make sure the operator and spotter are not wearing loose-
fitting clothing or jewelry, and long hair is tied up.
Make sure that there are no bystanders inside the work
zone and the spotter is not near a hazard.