Transport
WX520 / WX520L / WX520T
Log Splitter
26
7. Transport
7.1 Transport Safety
1.
Comply with local laws governing safety and transporting
of machinery on public roads.
2.
Do not exceed 50 mph (80 km/h) when towing this
machine. Slow down for rough terrain and cornering.
3.
Do not transport or move the log splitter with the engine
running.
4.
Be sure the trailer is hitched correctly to the towing vehicle
and a retainer is used through the hitch mechanism.
5.
Always attach safety chains between the hitch and the
towing vehicle. Cross the chains underneath the trailer
tongue.
6.
Check wheel lugs and tighten if required. Inspect rims for
damage.
7.
Inspect tires for cuts or damage. Check tire pressure and
adjust if required.
8.
Ensure the stability jacks are raised and secured with the
latch pin.
9.
Make sure tow vehicle is fitted with the correct size (2 in)
towing ball.
10.
Make sure fuel and hydraulic tank caps are on tight to
prevent spills while transporting.
11.
Clean all debris off the splitter. Remove any tools or other
loose items.
12.
Check that all the lights, reflectors and other lighting
requirements are installed and in good working condition.
13.
Never allow riders on the machine.
14.
Be a safe and courteous driver. Always yield to oncoming
traffic in all situations, including narrow bridges,
intersections, and so on.
15.
Watch for other traffic when near or crossing roadways.
16.
Do not drink and drive.
17.
Before transporting, perform a walk-around inspection to
ensure everything is safe.
7.2 Prepare for Transport
•
Stop the machine.
For instructions, see
.
•
Clean all debris from the splitter that could fall off in
transport.
•
Check tire pressure. Inspect for cuts or damaged rims.
•
Check lug nuts and re-torque as necessary. Inspect again
after 20–25 mi (32–40 km). Check weekly. See
•
Inspect and replace any axle dust caps that are missing,
damaged or leaking.
•
Always be in compliance with all applicable local
regulations when transporting.
7.3 Connect to a Tow Vehicle
1.
Keep bystanders are clear of the machine.
2.
Make sure there is enough room and clearance to safely
back up to the machine.
3.
Slowly back the tow vehicle until the coupler on the hitch
and ball are aligned.
00715
Figure 14 –
Align the ball hitch
4.
Lift the hitch and place the coupler over the ball on the
hitch.
5.
Flip the latch to lock the coupler around the ball.
6.
Pull out the jack stand snap lock pin and raise the jack
stand to its stowed position. Install snap lock pin to secure
it.
7.
Cross safety chains under trailer tongue and attach securely
to the tow vehicle hitch.
8.
Connect the wiring harness for the lights (as equipped).
9.
Reverse the above procedure when unhooking.
Summary of Contents for WX520
Page 40: ...WallensteinEquipment com...
