Wallenstein WX520, Operator'S Manual

Page: 22 / 40

Operating Instructions
WX520 / WX520L / WX520T
Log Splitter
22
6.5 Check the Engine Oil Level
IMPORTANT! For more information about engine oil, see
the engine manufacturer's manual and
Engine Oil on page
28 .
Operating the engine with a low oil level can cause engine
damage that is not covered by the warranty.
The engine must be in a level position for the
dipstick to show the oil level correctly.
Check the engine oil level before each use.
1. Park the machine on level ground.
2. Stop the machine.
For instructions, see
Stop the Machine on page 24 .
3. Pull out the oil-level dipstick and wipe it clean.
4. Fully insert the oil-level dipstick.
5. Pull out the oil-level dipstick and check the oil level.
The oil level is correct when oil is visible on the dipstick
from the end to the full (upper) mark.
6. Do one of the following:
-
If the oil level is correct, continue with step 7.
-
If the oil level is low, add oil until the oil-level is at the
full (upper) mark. For instructions, see
Add Oil to the
Engine .
7. Insert and secure the oil-level dipstick.
01758
Figure 7 –
Check the engine oil level
6.6 Add Oil to the Engine
IMPORTANT! For more information about engine oil, see
the engine manufacturer's manual and
Engine Oil on page
28.
The engine has three oil-fill locations. The two most accessible
locations are shown in the following image. The third location is
on the opposite side of the engine, below the dipstick.
1. Check the engine oil level to make sure that the oil level is
low. For instructions, see
Check the Engine Oil Level.
2. Turn an oil-fill cap counterclockwise to remove it.
3. Use a clean funnel to slowly add the correct type and
amount of oil.
Do not overfill.
4. Wait a minimum of one minute.
5. Remove the funnel, and then check the engine oil level.
6. Install and secure the oil-fill cap to prevent spillage.
01779
Figure 8 –
Engine oil-fill locations