Wallenstein FX Series, Operator'S Manual

Page: 29 / 56

FX85, FX110, FX140
PTO Skidding Winch
Controls
29
00834
2 3
1
Fig. 37 –
Receiver
1. Receiver
2. Manual override button
3. Storage mount for transmitter
5.11.3 Manual Override
The winch can be operated manually with the button on the front
of the receiver.
CAUTION!
Do not risk personal injury by standing in front of
the winch during operation. Do not use manual
override unless winch operation is necessary
and the remote is not functioning.
W050
Because of the location of the switch, the manual override
control must not be used on a continuous basis and should only
be used until the remote is back in service. Be aware of the rope
and load to avoid potential injury.
5.11.4 Transmitter Operation
Press and hold the ON button until the green
LED turns on, then release. The green LED
flashes rapidly when communication has
been established with the receiver. It flashes
slowly if the receiver is off or there is no
communication between the transmitter and
receiver.
Press and hold the UP arrow to retract the
winch cable.
Release the button to disengage the winch
and stop the cable retracting.
00833
Fig. 38 –
Remote Transmitter operation
NOTE: With the UP button released (clutch
disengaged), the winch drum can freespool so
cable can be pulled out.
5.11.5 Automatic Shutdown
The transmitter shuts down automatically after three minutes of
inactivity.
5.11.6 Synchronizing Transmitter and
Receiver
In the event it is necessary to synchronize a new transmitter and
receiver, use the following steps:
1. Remove the cover from the receiver.
2. On the circuit board, press the small receiver Function (F)
button. The function LED lights red.