Single Color Wall Mounted Touch ZigBee Remote Controller
09.ZG2TU3.04789
Function introduction
Important:
Read All Instructions Prior to Installation
Front side
Back side
19.4 mm
43.58 mm
6
5
.5
8 m
m
AC Power input
L
L
8
3
.0
0 m
m
ZigBee controller
N
N
AC POWER INPUT
Brightness wheel, slide
touch to select brightness
ON/OFF button, click to turn
ON/OFF all, press and hold
down to search and pair to
ZigBee network or factory
reset the controller
Note: This remote supports
1 group for binding max. 30
lighting devices. Each
group can save and recall 6
scenes.
25% brightness
50% brightness
75% brightness
100% brightness
Scene button, press and
hold down to save a scene,
click to recall the saved
Product Data
Transmission Range
(free field)
30m
Operating temperature
0-40°C
Relative humidity
8% to 80%
Dimming Range
0.1%-100%
Power Supply
100-240V AC
Operation Frequency
2.4GHz
Dimensions
120x75x29.1mm
Protection Type
Ip20
• ZigBee wireless dimmer switch based on ZigBee 3.0
• Full touch glass interface, smooth light intensity control
• Enables to pair ZigBee lighting devices via touchlink
commissioning without coordinator
• Supports find and bind mode to pair with ZigBee lighting
devices
• Supports 1 group for binding max. 30 lighting devices
• 2.4 GHz global operation
• Transmission range up to 30m
• Compatible with universal ZigBee Gateway products
• Compatible with universal ZigBee dimmable lighting
devices
•
DO NOT install with power applied to the device.
•
DO NOT expose the device to moisture.
Safety & Warnings
Operation
1.This ZigBee Dim remote is a wireless transmitter that communicates with a variety of ZigBee
compatible systems. This transmitter sends wireless radio signals that are used to remotely control a
compatible system.
2.This ZigBee remote supports 1 group for binding max. 30 lighting devices and enables to control
single color ZigBee lighting devices.
3. Zigbee Network Pairing through Coordinator or Hub
(
Added
to
a
Zigbee
Network
)
Step 1:
Remove the remote from
previous zigbee network if it has
already been added to it, otherwise
pairing will fail. Please refer to the part
"Factory Reset Manually".
Step 2:
From your zigbee controller or
hub interface, choose to add device or
accessory and enter Pairing mode as
instructed by the controller.
Step 3:
Press and hold down until LED
indicator turns on.
Step 4:
Immediately short press to
search nearby network, indicator
flashes every 1 second, 20 seconds
timeout if there is no network. Indicator
will then blink 5 times quickly for
successful pairing.
ZigBee Clusters Supported by This Remote Are As Follows:
Input clusters:
•
Basic
•
Power Configuration
•
Identify
•
Diagnostics
Output clusters:
•
Identify
•
Scenes
•
On/off
•
Level control
•
Ota
