Wallbox DC Charger 1ph, Installation Manual

Page: 12 / 20

12
EN
1.a Rear connection
1. At the rear side of the connector box, there is an area with a thinner wall
can be found; use a cutter or any sharp tool and make an incision for entry
of the cable.
2. Remove the four screws from the connector box and open it.
3. Remove the screws of the cable clamp.
4. Carefully and firmly insert the power cable through the sealing.
5. Connect the power cables in the right positions (see picture).
6. Close the connector box and screw it.
7. Insert the four anchors into each respective hole.
8. Place the wallplate in its position.
9. Fix the wallplate with four 6x30mm screws.
10. Make sure the previous steps have been completed correctly.
Neutral
Earth
Rear cable entry (1.a)
Lower cable entry (1.b)
Line
Picture 1.2