Wallbox DC Charger 1ph, Installation Manual

Page: 10 / 20

10
EN
• The power supply line must be wired to an existing installation and be in accordance
with local regulations.
• The charger must be electrically protected by installing externally a Miniature Circuit
Breaker (MCB) and a Residual Current Circuit Breaker (RCCB).
Electrical Protection
Recommended protections, take also into account the local regulations.
MCB: maximum value according to the maximum output current of the load point.
RCCB: According to local regulations, Type A or Type B.
Dimensions and Positioning of the Device
In accordance with the product standards, the charging station must be located at height between 1.30 m
and 1.70 m above ground level. The Plug Holder must be located between 0.50 m and 1.50 m above ground
level. Remember that local regulations may limit these heights. It is mandatory to consider the following
precautions:
• The mounting area required for the Wallbox charging
station is at least 130x55 cm (height by width).
• The area below an above the charger must be free of
any objects. The Wallbox charger needs this area to
dissipate its generated heat. See picture 0.1
• When installing the Wallbox, the cable should easily
reach the vehicle inlet.
• For a safe operation of your charging station, you must
observe the minimum distances recommended to
other technical installations
Minimun object - free area
50cm
50cm
50cm
50cm
Minimun object - free area
Picture 0.1
Ensure the charger is in vertical position, do not use it
in horizontal position.
Correct installation is absolutely essential and is
outside the scope of the liability of Wallbox.
Installation video available at https://wallbox.com