SafeFlame 800 / 220
2
OPERATION INSTRUCTIONS
Figure 6:
- black
+ red
Safeflame stove 800
Function description
- Wallas 800 heater is a single hot plate compact stove.
- The combustion gases and also the water vapours
produced by the combustion are discharged out
which keeps the boat interior dry and fresh.
- The ignition and start are automatic and the cooking
effect steplessly adjustable.
- The stove top is stainless steel and the nitrided, anti-
rust coated hot plate of iron.
Start
- Cooker The priming and heating is started
automatically. The switch pilot lamp indicates that
the cooker is switched ON by switching ON the ON/
OFF switch. At start the regulation knob should be
set on full effect until the red combustion control
lamp lights up. When switching off the cooker the
effect setting has no importance.
- A flashing switch lamp indicates too low supply
voltage caused by disharged battery, too weak
supply cable or poor contact in fuse or connections.
If flashing continues after the 2.5 min. priming (start)
cycle or occurs under operation the cooker will
switch off automatically.
- Re-start (after switching off) can not be made before
cycling the switch in OFF-position 5 min. and not
before the red combustion pilot lamp has gone out.
Combustion pilot lamp
- The red pilot lamp indicates that combustion is going
on. The lamp will normally light up in abt. 5 min.
after start, - if not, switch the ON/OFF switch to
OFF, wait abt. 5 min. and re-start.
- After switching off the cooker the red pilot lamp will
light until the cooker is cooled down, - about 10
min.
- A flashing red light indicates that the overheating cut-
out has switched off the fuel pump and cooker
because of overheating. The overheating cut – out
and fuel feeding will reset automatically after the
cooker is cooled down. Before continuing the use,
clear up the reason for overheating and take the
necessary steps to eliminate it.
Effect regulation
- The effect regulation is stepless (abt. 500 –1100 W).
- The regulation effect is almost instantaneous.
Switching off
- The cooker is switched off by turning the switch in
OFF-position. After this the combustion blower goes
for aftercooling until the red combustion pilot lamp
goes out.
- The battery supply to the cooker shall never be
switched off by a battery master switch before this.
Maintenance
- Dish washing agent and olive oli recommended for
cleaning and for protection of the hot plate after every
use.
The heat blower lid type 220
Function description
- The heat blower lid 220 blows the heat from the hot
plate to the cabin and converts the cooker in a
handturn an effective cabin heater. The blower lid
can be attached to the cooker also afterwards.
Start
- The blowers in the lid start automatically with some
minutes delay when the lid is closed and the lids
heat sensor feels the heat of the hot plate. The
blowers stop automatically when the hot plate is
cooled down after switching off and after rising the
blower lid.
