Heating on
30 s
30 s
Combustion has begun/is running
Set temperature on heater is higher than
cabin temperature - power is increasing
Set temperature on heater is lower than
cabin temperature - power is decreasing
Locked for security
The device locks itself
after two unsuccessful starts
Sun Switch has shut down the device
Cooldown/Flameout
I
Heating on in High Altitude Mode
I
Overheat
I
Reminder indicating there was a fault
after fault code flashed for 5 min
30 s
www.wallas.com
If the unit has locked itself,
the combustion light (1) and
the heating indicator light (7)
will flash signaling there has
been a failure that should be
investigated and resolved
prior to further use. Lights
will flash for about 5 min.
1) While the lights are still
flashing, switch the main
power off from the battery
(Pull power plug, remove the
fuse, open breakers, or in-line
switch).
2) Wait for 5 sec. and switch
the main power back on.
3) Press Power Button (3) for
more than 3 seconds to shut
down the unit.
4) Restart the unit normally.
UNLOCKING THE
UNIT
Reach Out to a Wallas Professional for the Following:
Glow Failure
2 s
2 s
Combustion Air Blower Fault
2 s
Main Blower Fault
2 s
2 s
I
I
I
Low voltage (usually about 15 sec
after initiating start)
I
See instructional video
to unlock
All rights reserved. Wallas-Marin reserves the right to change or improve its products and to
make changes in the content of this guide without obligation to notify any person or organization
of such changes or improvements. Go to www.wallas.com for current updates and supplemental
information concerning the use of this product.
PANEL LIGHTS
I
Sun Switch automatically turns the heater blower
lid off if the room temperature r3 C (37 F)
above the set level for 1/2 hour due to
temperature increase in local ambient conditions.
SUN SWITCH
(IN PI THERMO MODE)
Orange thermostat light will
begin to flash every 30 seconds.
Turn the
Power Knob
slightly to
turn the Sun Switch off
temporarily.
If heating is still needed, turn
the device back on manually.
see
ignition
When the device is used 1500 m (4,900 ft)
above sea level, it is necessary to activate the
High Altitude Mode to adjust the combustion.
I
I
HIGH ALTITUDE MODE
Start the stove by holding the
Power Button
down for 10
seconds.
Yellow heating light will flash 3
times and then change to a solid
yellow light. High Altitude Mode is
now on and the stove has started
the ignition process.
