9
(888) 253-0777
There is a detailed “HOW TO” video on the DVD and online:
https://www.youtube.com/watch?v=CxuAgcBzZpQ
Short Legs position
Remove knuckle, re-position
leg that holds the wheel
Long Legs position
Use a Phillips head screwdriver to change the position of the leg:
1. Remove the wheel/strut from the leg using the push button.
2. Loosen the knuckle with Phillips screwdriver, keeping the screws
and washers in place.
3. Reposition the leg on the high setting where you see the two holes
on the inside of the leg. This makes it 2" taller.
4. Align the knuckle and re-tighten the screws in the knuckle.
5. Make sure to keep the washers in place inside
the screws. Make sure the small black block is not
installed upside down. Adjust one side at a time
because the Left and Right knuckles are different.
You will see an L or R inside the plastic knuckle
block to indicate the correct position. Make sure
this is not upside down!
Stirrups
Stirrups are optional for paws that are dragging
or knuckling under. The stirrups attach to the back
of the wheelchair on each silver metal loop. The
rubber tubes on the stirrups need to be above Your
pet’s hock. Use the push lock to adjust to a snug
fit. Your pet’s leg should be several inches off the
ground. You can adjust the length of the cord by
re-tying the knot. If you use the stirrups, use both.
Using only one stirrup causes your pet to
feel unbalanced.
IMPORTANT: When taking the pet out of the
wheelchair, make sure to release the stirrups FIRST
.
hock
Black
block
Black block
