11
(888) 253-0777
The Velcro
®
center connector can be moved forward or backward to
avoid putting pressure on your pet’s genitals (ideal for intact pets).
In addition, the Velcro connector can be wrapped loosely so there
is space between the rings. The Velcro center connector MUST be
used. Adjust for best comfort and fit.
The rubber tubing can be cut shorter if
needed (do not cut the strapping). Try
cutting about a 1/2" off all four ends of the
rubber then adjusting the tri-glides on the
straps to tighten them up.
or
Excess Velcro
®
strapping on
the leg rings can crisscross
over rump.
Velcro
®
two sides
together to form handles.
Front Harness Attachment
Adjust the extenders so they reach the harness
clips on the front harness. The extender ends
will go through each D-Ring and then clip
into the front harness. The D-Rings should be
positioned just behind the shoulder blades.
Adjusting the Front Harness:
• Take the three black comfort sleeves off
the harness so you can make sizing
adjustments.
• Your pet’s head goes between the black straps.
• Red strap goes behind the front legs and clips
into the side of harness.
• Male prongs point to the back, and clip into the
wheelchair.
• All three straps should be snug.
• Comfort sleeves can be cut in half for smaller
pets and excess straps tucked in.
This material will not fray.