Step 3: Move the throttle trim, elevator trim, aileron trim, and
rudder trim at the neutral positions, respectively.
19
Step 4: Connect the power cable of the Aircraft and wait
to receive the signal from the transmitter. The
Aircraft should be placed on flat ground or
surface during code paring (binding). Do not
move the transmitter sticks or the Aircraft until
binding has completed.
Step 2: Turn all the switch of transmitter to "0" position,
push the throttle stick to the lowest position,
turn on the transmitter power.
12
Steps of
flight
13
Flight over
Step 1: Open the battery compartment, install the battery pack
into the battery compartment along the arrow direction.
Step 1
Step 3
Step 4
Step 2
Step 1: disconnect the power cable
of Aircraft .
Step 2: turn off the transmitter.
Step 3: take off the battery pack.
Step 1
Step 3
Step 2