1
8
9.1 The flowchart of GPS Satellites Signal(Need to connect with GPS module)
The starting position means a point before the departure of the flight control system initialization and automatically
check the complete aircraft location.
9.2 Position Hold
9.2.1 Here pre-conditions for Hold Position:
(1) The Aircraft is in normal flight statusand battery voltage is normal.
(2) GPS function and signal are both in good condition( the right Green LED indicator should blink over 2 times).
(3) Compass should be calibrated well. And the THRO trim, ELEV trim, AILE trim, and RUDD trim at the neutrla positions.
(2) Please use manual mode to start to fly, switch to hold position mode the aircraft will hover stable, after landing to
the ground and push the throttle stick to the lowest position, the motor can lock automatically,and later need
to re-switch to manual mode the motor can unlock.
9.2.2 Note
9.3 One Key Go Home
9.3.1 Here pre-conditions for One Key Go-Home:
Suggestion: For GPS mode flight, Right green LED indicator should blink over 2 times.
(1) The Aircraft is in normal flight statusand battery voltage is normal.
(2) GPS function and signal are both in good condition( the right Green LED indicator should blink over 2 times).
(3) Compass should be calibrated well. And the THRO trim, ELEV trim, AILE trim, and RUDD trim at the neutrla positions.
Position Hold Setup:
One Key Go Home Setup:
09
Advanced
function
specification
GPS Satellites
The right
Green LED
status
<6 6 7 8 9 10 11 12 13
No
blinking
Blinking
once
Blinking
twice
Blinking
3 times
Blinking
4 times
Blinking
5 times
Blinking
6 times
Blinking
7 times
Blinking
8 times
When toggle the MIX switch to "1"position(don't move
other sticks) during flight under manual mode, it means
the QR X350PRO entered Position hold mode.
Please
keep the throttle stick at neutral position under this mode
.
If GPS signal lost, the aircraft will enter into altitude hold
mode.
When toggle the MIX switch to "2" position(don't move
other sticks) during flight under manual mode, it means
the QR X350PRO entered One Key Go Home.
Please
keep the throttle stick at neutral position under this mode
.
(1) The flight status can be controlled by radio under GPS position hold mode. Throttle stick should be neutral
first if you want the QR X350PRO hold at other points.
Starting position is the place where the main control board finishes initialization and auto check before
taking off.
h
1
h
2
(E
1
,N
1
,h
1
)
(E
2
,N
2
,h
2
)
Ground
Position Hold hover
Hover point 1
Hover point 2
N
S
E
W
N
S
E
W
MIX Switch
to“1”Position
Throttle stick
return neutral
MIX Switch
to“2”Position
Throttle stick
return neutral