7
5.0 Check Battery Levels
Turn on the remote controller and intelligent flight Battery to check the battery level.
Be sure the battery was fully charged at the first use.
1) Long press the power button for 2~3 seconds to turn on the remote controller.
(Repeat this operation to turn off the remote controller).
2) Battery Electricity Detection Switch to turn on the Electricity Indicator---the green light is always on.
(Repeat this operation to turn off the Flying Battery Electricity Indicator).
Low
High
6.0 Aircraft charging
Connect the AC power, turn on the power switch, the charger will “click”, the fan will rotate once, and the LCD
will display the following interface.
Battery type (lithium battery/
high voltage lithium battery)
Charging current (1.0-20.0 A)
1.0A
LiPo
FAST CHARGE
Stand-alone
Charging mode (fast charging, precise charging, battery storage)
Synchronization status (single, master, slave)
6.1 Power on
①
Connect the balance charging cable as shown by the red arrow.
②
Connect the battery charging cable as shown by the blue arrow(Choose any red and black cable.)
Please connect the battery and charger according to the connection as shown below, as shown below:
(Note: The number of lithium battery packs that support charging is 12 knots; the battery charging cable and
the balance port must be connected to the charger at the same time.)
6.2 Connect the battery
6.3 To Start Charging
LiPo
FAST CHARGE
Stand-alone
2.0 A
LiPo
FAST CHARGE
Stand-alone
2.0 A
LiPo
FAST CHARGE
Stand-alone
2.0 A
LiPo
FAST CHARGE
Stand-alone
2.0 A
1) Press the key
and the charging
mode will flash.
2) Press the or
key to select
“FAST CHARGE”.
3) Press key again, the
current option starts to flash,
press or to set the
charging current, the current
is recommended to be 2.0A.
4) Long press the
key for 2 seconds and
then press the key
to confirm, and start
charging the battery.
Low
High
Walkera All Rights Reserved
Quick Start Guide
快速充
单机
①
②
②
LiPo Battery
Charger
