ASSEMBLY
OM 0182SB-A
14
Figure 12
Driveline
Installation
Figure 12
Figure 13
6. Figure 12:
Insert the male quick hitch
section (item 1) into the female hitch
(item 2) and lock in place by moving
lever (item 3) to lock position (fully
forward), and secure latch with linchpin.
7.
Grease the drive shaft sliding surfaces
and slide the male shaft inside the
female tube.
8.
Attach the driveline quick lock coupler to
the tractor PTO.
WARNING: This shaft turns at high
RPM. If the collar is not locked to the
shaft at the tractor end, or if the yoke at
the blower end is not secured properly,
the drive shaft can fly loose with great
force, capable of causing serious injury
or death.
9. Figure 12:
Attach parallel bar (item 4) to
female hitch and to implement adaptor
using the two clevises and hairpins.
10. Figure 13:
Insert the rotation handle
(item 1) into the rotation worm (item 3).
Align holes and lock in place with a 1/4"
x 1" hex. bolt and nylon lock nut.
11. Figure 13:
Install the plastic handle
(item 2) on the chute rotation handle
(item 1).
Removing Snowblower from
Tractor
(Figure 12)
1.
Select a level surface, set parking brake
and remove ignition key.
2. Figure 12:
Remove hairpin from parallel
bar at adaptor end, and remove parallel
bar (item 4) from implement adaptor.
3.
Disconnect driveline from tractor PTO
shaft.
4. Figure 12:
Remove linchpin from quick
hitch latch and place quick hitch lever
(item 3) rearward to unlock position.
5.
Carefully remove quick hitch from
snowblower.
