−
Don´t operate the device with wet hand or feet.
−
Please only follow this instruction manual for cleaning the device.
−
Make sure, that cables and conductors won´t be damaged. Damages
could be caused through heat impact, chemical influence or through
mechanical impacts as rubbing, bending, tearing, rolling over or nibbling
animals.
−
Prevent your device against falling down.
In case of falling down, please let an electrician check the device before
switching on again.
−
If your device should be damaged or defect or if you notice a burning
smell:
Disconnect the power supply by pulling out the power cord
immediately. Never operate your device with damaged housing, defect
lamps or damaged power cord. Don´t open the device. Never repair the
device on your own. The device should only be repaired by electricians.
−
Please follow this instruction manual for maintaining your device.
−
Please just use spare parts, which are conform to the required
specifications. See
Technical Specifications
.
WARNING
Fire danger through overheating
The device can overheat, when you operate it with mounted protection
cap. The device itself and easily inflammable materials in close distance
could catch fire.
−
Don´t operate the device with mounted protection cap.
−
Don´t cover the ventilation slots of the device during operation.
−
Remove easily inflammable materials, which are in close distance to the
device.
−
Please just use spare parts, which are conform to the required
specifications. See
Technical Specifications
.
WARNING
Fire danger through hot parts
The modeling lamp and the flash tube can heat up up to 240°C, the reflector
up to 72°C. Easily inflammable materials can catch fire, if they are placed
too close beyond a hot part.
−
Don´t cover the ventilation slots of the device during operation.
−
Remove easily inflammable materials.
WARNING
Danger of burning on hot parts
The modeling lamp and the flash tube can heat up up to 240°C, the reflector
up to 72°C.
−
Don´t touch the parts during operation and cooling down.
−
Please cool down your device approx. 30 minutes before starting any
mounting or maintenance arrangements.
WARNING
Danger of cutting and splitting through breaking modeling lamp and
breaking or bursting flash tube.
Even small residues of skin oil on the flash tube could lead, due to the
high heat impact, to the splitting of the flash tube. Broken glass could
hurt eyes and skin.
−
Please handle the modeling lamp and flash tube with care to avoid
bursting.
−
Don´t touch the flash tube with bare hands. Wear cotton gloves or use a
clean cloth.
−
Avoid touching the flash tube accidentally when mounting or changing
accessories.
7
6