6
humidity or moisture. A short-circuit can warm up the conductors, so that
there isolation will melt or even melt thoroughly. This could lead to fire.
−
Please just use the original cables, which are included in delivery.
They are aligned for your device and guarantee the necessary safety
for you and your device.
−
Don´t operate the device with wet hand or feet.
−
Operate the device only in dry rooms.
−
Don´t operate the device outdoors.
−
Please only follow this instruction manual for cleaning the device.
−
Make sure, that cables and conductors won´t be damaged. Damages
could be caused through heat impact, chemical influence or through
mechanical impacts as rubbing, bending, tearing, rolling over or
nibbling animals.
−
Prevent your device for falling-off.
In case of falling-off, please let an electrician check the device before
switching on again.
−
If your device should be damaged or defect or if you notice a burning
smell:
Disconnect the power supply by pulling out the power cord
immediately. Never operate your device with damaged housing,
damaged reflector, defect lamps or damaged power cord. Don´t open
the device. Never repair the device on your own. The device should
only be repaired by electricians.
−
Please follow this instruction manual for maintaining your device.
−
Please just use spare parts, which are conform to the required
specifications.
See
Technical Specifications
.
WARNING
Fire danger through overheating
The accessories can overheat, if it does not comply with the necessary
specifications.
The device itself, accessories and easily inflammable materials in close
distance could catch fire.
11
6.3
Screw in and out of lamp
WARNING
Danger of cutting and splitting through breaking or bursting lamp
Don´t let the lamp fall down.
Don´t touch the lamps with bare hands. Just touch the lamp at the plastic
socket or wear clean cotton gloves or use a clean cloth.
ADVICE:
Possible discolouration through burn marks on the lamps.
1.
Switch off device.
See
Switch on and off of the device
.
2.
Disconnect from power supply:
Plug out power cord.
3.
Let the device cool down.
CAUTION!
Danger of burning on lamps. Let the device cool down for
approx. 10 minutes.
4.
Screw in lamp:
Screw in the lamp carefully.
WARNING!
Danger of electric shock. Always screw in the lamp as to
avoid touching in the socket, when the device is switched on.
5.
Screw out lamp:
Screw out the lamp carefully and store it securely.
6.4
Connect to power supply
1.
Switch off device.
See
Switch on and off of device
.
2.
Compare the local power supply with the connected load of the device.
See
Technical specifications
.
If the values differ, please contact
or tel. +49 84 32
/ 9489-0.
3.
Connect the power cord with the socket on the device and with the
power socket.
