8
See
Technical Specifications
.
If the values should differ, please contact
or tel. 49
84 32 / 9489-0.
5.
Connect the power cord with the socket on the device and with the
power socket.
6.2
Connect the transmitter with the camera
1.
Put the transmitter with the shoe on the flash socket of your
camera.
2.
If your camera should not have a hot-shoe, please use the included
sync cord and connect the transmitter with your camera or flash
shoe.
7.
Operation of the device
7.1
Trigger test button
1. Before starting your work, please check the function of your devices
and trigger your studio flash through the test button on the
transmitter.
Test Button
Connection Socket Sync Cord
Transmitter/Camera
Transmitter
with shoe
Camera
with flash
socket
5
2.
Important safety notes
WARNING
Danger of electric shock, burn hazard
Please note, that the device is still connected with the supply voltage
even if it is switched off. Just after disconnecting the device from the
power supply through pulling out the power cable, the device is actually
de-energized.
−
Disconnect from power supply by unplugging the power cord before
starting any maintenance arrangements.
−
Disconnect from power supply by unplugging the power cord when
the device is not in use for a longer time.
WARNING
Danger of electric shock, fire through short-circuit
A short-circuit could be caused through defect cables and through
humidity or moisture. A short-circuit can warm up the conductors, so that
there isolation will melt or even melt thoroughly. This could lead to fire.
−
Don´t operate the device with wet hand or feet.
−
Operate the device only in dry rooms.
−
Don´t operate the device outdoors.
−
Please only follow this instruction manual for cleaning the device.
−
Make sure, that cables and conductors won´t be damaged. Damages
could be caused through heat impact, chemical influence or through
mechanical impacts as rubbing, bending, tearing, rolling over or
nibbling animals.
−
Prevent your device for falling-off.
In case of falling-off, please let an electrician check the device before
switching on again.
−
If your device should be damaged or defect or if you notice a burning
smell:
Disconnect the power supply by pulling out the power cord
immediately. Never operate your device with damaged housing,
defect lamps or damaged power cord. Don´t open the receiver. Never
