32
WARNING
Danger of electric shock, fire through
short-circuit
A short-circuit could be caused through
defect cables and through humidity or
moisture. A short-circuit can warm up the
conductors, so that there isolation will melt
or even melt thoroughly. This could lead to
fire.
■
Please just use the original cables,
which are included in delivery. They are
aligned for your device and guarantee
the necessary safety for you and your
device.
■
Don´t operate the device with wet hands
or feet.
■
Operate the device only in dry rooms.
■
Don´t operate the device outdoors.
■
Please only follow this instruction
manual for cleaning your device.
■
Make sure, that cables and conductors
won´t be damaged. Damages could be
caused through heat impact, chemical
influence or through mechanical impacts
as rubbing, bending, tearing, rolling over
or nibbling animals.
■
Prevent your device for falling-off. In
case of falling-off, please let an electri
-
cian check the device before switching
on again.
■
If your device should be damaged or
defect or if you notice a burning smell:
Disconnect the power supply by pulling
out the power cord. Never operate your
device with damaged housing, damaged
reflector, defect modeling lamp, defect
flash tube or damaged power cord.
Don´t open the device. Never repair the
device on your own. The device should
only be repaired by electricians.
■
Please follow this instruction manual for
maintaining your device.
■
Please just use spare parts, which are
conform to the required specifications.
See Technical Specifications.
WARNING
Fire danger through overheating
The device can overheat, if you operate
it with mounted protection cap or with
covered ventilation slots. The device itself
or easily inflammable materials in close
distance could catch fire.
■
Don´t operate the device with mounted
protection cap.
■
Don´t cover the ventilation slots of the
device during operation.
■
Remove easily inflammable materials.
■
Please just use spare parts, which are
conform to the required specifications.
See Technical Specifications.
WARNING
Fire danger through hot parts
The modeling lamp and flash tube could
heat up up to 240°C, the reflector up to
75°C and the flash housing up to 45°C.
Easily inflammable materials could catch
fire, if they get in contact with hot parts.
■
Don´t cover the ventilation slots of the
device during operation.
■
Remove easily inflammable materials.
EN
