Waldorf RNL8510GC, Installation And Operation Manual, Page: 25 / 34

23
Pilot Injectors
a. Unscrew and remove the Pilot Injector Plug from the fitting
at the end of the pilot injector tube using a 11 mm A/F
spanner. (See Fig 23).
b. Using a flat bladed screwdriver, unscrew and remove the
pilot injector from the pilot injector housing.
NOTE Take care not to lose the spring fitted in front of the
injector.
c. Remove existing pilot injector and replace with the correct
size pilot injector for the gas type being used. Refer to the
‘Gas Specifications’ table at the end of this section, for
correct pilot injector sizes.
d. Refit the spring and the correct pilot injector to the pilot
injector housing.
e. Screw the pilot injector fully home using a flat blade
screwdriver and refit the pilot injector plug to the pilot
injector housing and tighten in place using a 11 mm A/F
spanner. (See Fig 23).
f. Refit the splash guard over the gas cocks taking care not to
damage the thermocouples and pilot burner tubes. S ecure
in position with the 2 allan headed screws. (Note that the
splash guard for 'PF' models has a different cut-outs for
pilot burner tubes. See Fig 24 & Fig 25).
g. Refit the pilot burner tube shields over the pilot burner
tubes / thermocouples and secure in place with the 2
securing screws. (See Fig 21).
h. Refit the burner caps and burner bowls onto the manifolds
protruding through the splash guards. Take note that the
base part of the burner bowl has 2 locating holes drilled
into the base flange, (See Fig 17). these are to locate the
burner bowl onto the allen headed screws that secure the
splash guard to the gas manifold. (See Fig 15).
i. Refit all the trivet supports to the top of the appliance.
Note the orientation of the trivet support when re-fitting as
the front end side rail profiles are different from the rear
end side rail profiles. (See Fig 14).
j. Refit the trivets to the top of the appliance taking note that
the trivets are manufactured with a lip on one edge, the lip
must always be fitted to the outer edge (front and back) of
the Cooktop. (See Fig 18).
Low Fire Adjustment
a. To adjust the open burner low fire adjustment, remove the
gas control knobs from the front of the control panel.
b. Adjust the low fire adjustment screw on the open burner
gas control valves to obtain the desired flame size. (See
Fig 26).
NOTE: The “Low Fire Screw” should be sealed with coloured
paint on completion of the low fire adjustment.
Gas Conversion and Specifications
Pilot Injector
Plug
Pilot Injector
Housing
Low Fire Adjustment Screw
Fig 26
Fig 23
Fig 24
Cut-Out for Pilot
Burner &
Thermocouple
Fig 25
Shown without Pilot
Burner Shield fitted.
Pilot Burner
Thermocouple