12
NOTE: Only non-combustible materials can be used in close proximity to this appliance.
*
Side clearances can be 50mm when adjacent surface is at least 100mm below cooking surface.
NOTE:
All Models are delivered completely assembled. No further assembly is required, with
exception of all Leg Stand Models (RN8400G-LS, RN8600G-LS RN8800G-LS), these will
require assembly. Refer to 'Leg Stand Models Only' information below for assembly
instructions.
The appliance rear leg housings can be fitted with:-
Adjustable feet to assist with levelling of appliance on uneven floors. This should be
carried out on completion of gas connection. Refer to 'Gas Connection Section'.
Rear rollers to enable appliance to be easily moved for positioning and cleaning
purposes.
Optional Accessories (Refer to Replacement Parts List)
Plinth Kit. For installation details, refer to instructions supplied with each kit.
Bench Models
1.
Check that all feet are fitted.
2.
Adjust the four feet to make Cooktop steady and level.
1.
Remove all pot stands, pot stands supports, burner caps, burner bowls, griddle plates and other
removable items.
2.
Lower cooktop onto its rear face.
3.
Attach four cooktop legs to leg mount points on underside of cooktop unit.
4.
Secure each leg hand tight.
5.
Align 4 round holes in corners of base tray with 4 cooktop legs already fitted. (Ensure base tray is
orientated with sloping edge of base tray facing front of appliance).
6.
Slot base tray onto 4 cooktop legs and push fully home.
7.
Secure base tray to cooktop legs by screwing two front adjustable feet supplied, into base of front
cooktop legs. Secure each adjustable foot, hand tight.
8.
The two rear leg housings can be fitted with either adjustable legs or rollers. (See Figure 1).
Left / Right Hand Side
250mm (*)
0mm
Rear; -
Standard Models
50mm
0mm
-
Low Back Models
100mm
0mm
TO
PREVENT
EQUIPMENT
DAMAGE
AND
RISK
OF
INJURY
,
REMOVE
ALL
LOOSE
ITEMS
FROM
THE
TOP
OF
THE
COOKTOP
PRIOR
TO
FITTING
THE
LEG
STAND
.
