8
Installation
NOTE: The operating pressure to be measured at
the manifold test point and with both
burners operating at the “High Flame”
setting.
8.
Turn off the mains gas supply and bleed the gas
out of the appliance gas lines.
9.
Turn on the gas supply and the appliance.
10. Verify the operating pressure remains correct.
Commissioning
1.
Before leaving the new installation;
a. Check the following functions in accordance with the operating instructions specified in the
“Operation” section of this manual.
•
Light the Pilot Burner.
•
Light the Main Burners.
•
Check the Low Fire burner operation.
•
Check the High Fire burner operation.
b. Ensure that the operator has been instructed in the areas of correct lighting, operation, and
shutdown procedure for the appliance.
2.
This manual must be kept by the owner for future reference, and a record of
Date of Purchase,
Date of Installation
and
Serial Number of Appliance
recorded and kept with this manual.
(These details can be found on the Rating Plate attached to the R/H side panel (refer to
the “Gas Connection” section).
NOTE: If for some reason it is not possible to get the appliance to operate correctly, shut off the
gas supply and contact the supplier of this appliance.
Pressure Test Point
Low Fire Adjustment
Fig 3
