Waldbeck 10033393, User Manual

Page: 25 / 72

25
EN
6. Remove the upper filter plate by loosening the two screws.
7. Remove the filter sponges and clean them under running water. Wring
out the filter sponges vigorously.
8. Pull on the lower filter plate.
9. Clean the filter box, the lid with grid tube, the two filter plates and the
clamping ring by spraying them with a water hose.
10. Lightly lift the bypass valve and clean the inlet comb of the filter (see
illustration).
11. Clean the cover gasket and the edge of the filter box.
12. Slide the filter plate with the collar up on the mesh tube and cleaning
rods.
13. The filter sponges will be pushed out from the housing cover, starting
with a large blue filter sponge and always alternating with a small yellow
filter sponge. The cleaning rods are located in the two openings of the
large chamber of the filter sponges.
14. Place the filter plate with the collar down, fasten the cleaning rods flush
with the two screws on the filter plate.
15. Place the lid gasket on the top of the filter box and allow the gasket to get
wet for easy installation.
16. Place the lid with the filter sponge unit onto the filter box.
17. Place the clamping ring on the edge of the filter box and lid, push the lid
down and click to fix into place.
Push in the safety lock.
18. Secure all hoses with flat gaskets or flow blades to the appropriate port
by tightening the nuts.
19. Switch on the pressure filter again