Waldbeck 10033393, User Manual

Page: 23 / 72

23
EN
CONNECTION TO WATER SUPPLY
Slide the nut onto the black spiral-shaped hose adapter. Insert the flat gasket
into the nut and screw it firmly onto the water inlet nozzle.
We recommend that you divert the cleaned water, for example over a small
stream, rather than leading it directly back into the pond. This enriches the
water with additional oxygen.
Connecting to cleaning connection You can have a drainage hose permanently
connected to the cleaning connection. This allows you to drain the dirty water
directly into the sewerage system or onto a flower bed.
Connection of pressure filter
Before putting your new pond filter into operation, make sure that all cable
and hose connections are correct and that the sealing rings are not tilted. The
switch must be set to ‘filter function’ and you should follow the instructions
below.
1. Switch on the pump.
Attention: The UV-C lamp must not be put into operation before the pump is
pumping water.
2. Check that all connections are waterproof.
3. Connect the filter. The indicator light now illuminates with a blue light.
During the first or a new installation, full cleaning performance will only
develop after a few weeks after the necessary microorganisms have formed.
This occurs particularly quickly at ambient temperatures above 10 ° C.
Choose a suitable location for the pressure filter. Please observe the
installation guidelines regarding the clear water guarantee as well as the
following guidelines. Install the filter so that it is protected from flooding.
Secure your filter so that it does not fall into the pond. It should be located at
least 2 metres from the pond.