Wake N Grill Page 11
Step 3:
Position Lower Tube.
Install the Lower
Tube onto the Clamp using (1) 1/2”-13 x 2-1/4”
Socket Head Cap Screw and hand tighten bolt.
Carefully rotate the Lower Arm assembly and
engage the Hirth teeth in the closest position
to make the lower tube parallel with the swim
platform.
See Figure 22.
If needed, repeat steps (2-3) using different
position combinations in the clocking table until a
satisfactory level tube position is obtained.
See
Figure 23.
HINT:
To check actual position of Lower Tube,
pull down on the aft end of the tube to rotate
and “seat” the entire assembly to simulate an “as
used” position. This will remove any gaps from
built in tolerances of the parts.
NOTE:
It may take multiple trials to figure out
the right combination for your boat, proceed with
the table of adjustments until the fit is visually
satisfactory. Remember you will be floating in
constant motion, perfection is only noticeable on
shore, ballast can fix the rest.
Step 4:
Secure all Parts.
Once a satisfactory
position of the Lower Tube is found, temporarily
remove the Lower Tube from Clamp to apply
Loctite to all fasteners.
Individually remove (3) 1/4”-20 x 5/8” Flat
Head Cap Screws from the Clamp hirth joint and
reinstall after applying Loctite 243 threadlocker
(included) to the threads. Tighten screws.
See
Figure 21.
Individually remove (3) 1/4”-20 x 5/8” Flat Head
Cap Screws, from the lower tube hirth joint and
reinstall after applying Loctite 243 threadlocker
(included) to the threads. Tighten screws.
See
Figure 21.
Apply Loctite 243 threadlocker (included) to the
threads of (1) 1/2”-13 x 2-1/4” Socket Head Cap
Screw. Install WNG-LWR-TB assembly onto the
WNG-UNI-CLAMP assembly and hand tighten the
bolt. Ensure the tube is in a satisfactory position
and then perform final torque. (approx. 55 ft-lbs).
See Figure 22.
Step 5:
Install Pull-Pin.
Determine which side of
the lower tube is most convenient to reach from
the swim platform. The Pull-Pin (WNG-PULL-PIN)
can be installed on either side of the Lower Tube
threaded boss.
See Figure 24.
Apply Loctite 243 threadlocker (included) to the
threads of Pull-Pin. Tighten using an adjustable
wrench on the flats of the Pull-Pin base. DO NOT
overtighten, it will damage the slide mechanism of
the pin.
Install Lower Tube
Figure 22.
6ZLP6WHS
/RZHU7XEH
$VVHPEO\
3XOO3LQ
0D\EHPRXQWHG
RQRWKHUVLGH
7KUHDGHG%RVV
Lower Tube Parallel with Swim Step
Figure 23.
/RZHU7XEH
$VVHPEO\
[
HDG
&DS6FUHZ
8QLYHUVDO&ODPSV
Install Pull-Pin
Figure 24.
