Wake N Grill Page 17
inner tube into the outer tube and lock into place
using spring lock button. Open the umbrella and
lock in place.
Install the lower tube over the Unbrella Plug by
depressing the Unbrella Plug snap button. Align
the snap button with hole in the lower umbrella
tube to lock in place.
Step 3: Stow Umbrella.
Simply reverse above
steps.
Stowing Wake N Grill:
CAUTION:
The Grill and accessories should never be
stowed until they are cool to the touch. Stowing
hot items could result in injury and damage the
storage bag. Marine grills are designed to cool
very quicky, so please be patient before stowing.
If you’re thinking about it, it’s probably too hot.
Step 1:
Remove Propane, Regulator, and
Cutting Board.
Make sure the grill is turned off
(see manufacturer’s instructions) and properly
cooled. Remove propane tank and propane
regulator (if applicable) and stow items in Storage
Bag.
Twist the Fin Lock to stowed position and remove
cutting board by tilting upwards and lifting out.
Stow in Storage Bag.
HINT:
Rinsing the cutting board now is a good
idea if you like clean things
Step 2:
Remove Umbrella.
If equipped remove
Umbrella (see Umbrella Stowing Section)
Step 3: Clean.
Now is a great time to clean the
grill and the grease trap (below grill) prior to
removing, then close and lock lid.
While holding the Grill by it’s handle, pull and
twist the Pull-Pin shaft 90 degrees to lock it in the
open
position. Remove Grill assembly from the
Mid-Arm by lifting the assembly upwards.
Stow Grill assembly in Storage Bag.
HINT:
Best practice is to store the grill on its back
(Handle up, regulator side towards propane
pockets) with the Serving Tray underneath to
catch any grease or leftovers.
Step 4: Stow Mid-Arm.
Using the Multi-Tool or
optional Spatula, loosen the Twist-Lock on the
Mid-Arm.
Lower the Upper Slide Tube to the lowest position
for storage, aiming the Pull-Pin inboard, hand
tighten the Twist-Lock.
Reach under the swim platform and pull and twist
the Pull-Pin shaft 90 degrees to lock in the
open
position.
Remove the Mid-Arm assembly from the Lower
Tube by sliding the mid arm out of the tube
towards the rear of the boat. Place Mid-Arm
assembly into the neoprene sleeve and stow.
Mid-Arm Sleeve and Storage Bag
Figure 34.
