249.805.013
30
Date: 2021-12-09
LED Functions
DMX LED
The DMX lamp will be steady green when receiving a DMX signal.
The DMX lamp will flash green if no DMX signal is present.
Error LED
The error LED will light red if there is an error.
Reset error is done by setting DMX channel 4 to 0%.
When the Error LED lights red, there will also be an error description in the display.
Error and error codes
Error
Possible solution
Roll Down will not start,
display shows nothing.
Check if the Roll Down is connected to mains power.
Check if the fuse in the Roll Down is intact
Roll Down will not start, DMX
lamp is blinking.
Check DMX signal
The fabric is not wound up on
the tube correctly.
Manually lower the fabric totally off the tube, while inspecting that the fabric
comes out of the Roll Down evenly. Afterwards the fabric is rolled back onto
the tube.
Reset the top position afterwards.
Display says “Not in Pos”
The Roll Down cannot move to its position, this usually occurs when the load is
high. To solve this, go into the menu and increase the Minimum speed up.
Display says “NO MOVEMENT
DETECTED”
The Roll Down does continuously not measure any movement when trying to
move. To solve this, check that the curtain has not caught onto something. If
not then go into the menu and increase the Minimum speed up.
Power failure
The Roll Down will stop at power failure. When the power is re-established, the
Roll Down must be reset before it is ready to use.
It is advisable to set all the DMX channels on 0% before the power is re-
established.
When an error occurs, the control system shuts down the connected motor and issues a
corresponding error code. This can be queried and used to determine the cause of the error.
