249.805.013
24
Date: 2021-12-09
POS OUT
Position feedback
This feature enables you to know exactly where the Roll Down is. The position feedback outputs a DMX signal on
pin 1,4,5 of the DMX in/out plugs. All values are zero except for the feedback which is located at the DMX address
of the device. Meaning if the Roll Down has starting channel 73 then the 16bit feedback will be at channel 73 and
74. The menu options are
-
OFF: No output
-
SCALE: 16 bit scaled feedback. The feedback will be 0,0 at the bottom and 255,255 at the top
-
DIV 4: 16 bit raw feedback divided by 4. The feedback will be 0,0 at the bottom and TAC RANGE divided
by 4 at the top. For a 10 meter span this is roughly 77,104.
-
32BIT: 32 bit raw feedback. This feedback will be 0,0,0,0 at the bottom and TAC RANGE at the top. For a
10 meter span this is roughly 0,1,53,161.
UNSAFE MODE
Disable all limit switches
CAUTION!: UNSAFE MODE should only be used in emergency situations. It disables both limit switches, and
emergency stop.
NOM. FREQ
Power input frequency
50/60
Frequency of the national grid of installation.
REVERSE DIR
Reverse direction of up and down
OFF/ON
Reverse motor movement, encoder, and limit switch direction.
QUICK SLACK
Stop quickly when slack activates
OFF/ON
This option has no effect on the Roll Down
PRECISION
Tolerance for settling
5
–
100
The tolerance in which the Roll Down will stop. To small a precision will lead to the Roll Down overshooting its
wanted position and never stop. This will cause the motor to overheat and eventually get damaged.
SLS DIST
Kilometres moved Since Last Service
Shows how many kilometres the Roll Down has travelled Since Last Service reset (SLS RESET).
SLS TIME
Hours moving Since Last Service
Shows how many hours the Roll Down has been moving Since Last Service reset (SLS RESET).
SLS ON
Hours powered on Since Last Service
Shows how many hours the Roll Down has been powered on Since Last Service reset (SLS RESET).
SLS RESET
Reset Since Last Service parameters
NO/YES
Set all SLS values to zero. Go through all service steps described in the manual and contact Wahlberg Motion Design
for any spare parts.
TOT DIST
Kilometres moved in total
Shows how many kilometres the Roll Down has travelled since production.
TOT TIME
Hours moving in total
Shows how many hours the Roll Down has been moving since production.
TOT ON
Hours on in total
Shows how many hours the Roll Down has been powered on since production.
FACTORY RST
Reset to factory default settings
NO/YES
Reset all menu values to its default settings.
