11
HOT & COLD MASSAGER
OPERATING INSTRUCTIONS
1. With the switch in the OFF position, plug the power
cord into an AC outlet. (Make sure the voltage
of power supply is the same as that indicated on
massager.)
2. Place the desired massage attachment on the
massager. The attachments easily press on and pull
off, if heat is desired, the heat attachment must be
used. (See DEEP HEAT ATTACHMENT below).
If cold massage is desired, the cold gel attachment
must be used. (See COLD GEL ATTACHMENT
below).
3. Variable speed allows you to personalise your
massage. For best results, begin at the lowest
speed setting, and gradually increase to the desired
massaging speed by rolling the dial toward the top
of the massager. Roll the dial toward the bottom of
the massager to decrease the speed.
4. Push the top switch for the heat setting. Use heat
only with the deep heat attachment. Heat may be
applied alone or with the massaging feature.
5. Apply the massager to the targeted area, using
continual movement. A circular motion is often most
effective. (See MASSAGE TECHNIQUES.)
CHANGING ATTACHMENTS
To remove an attachment head, grip firmly and pull.
To insert an attachment head, place the head on the
stem and press firmly.
