Wahl Bach marey PP4 Instruction Manual Download Page 2

2

3

EN

EN

Safety Instructions

Contents

Marey Electric Tankless Water Heater by Wahlbach

Marey Electric Tankless Water Heater by Wahlbach

1.  Safety Instructions

Congratulations and thank you for choosing our instant water heater. The instruction 
contains important information about commissioning, switching the device on and main-
tenance. To ensure your safety and that of others, we recommend you read through this 
safety manual carefully. Please refer to the back of the manual for details about the war-
ranty. Keep this manual for future reference.
If you lose the manual, contact your local distributor or manufacturer. When you call, 
please tell us the model number and the serial number of your unit written on the rating 
plate of the water heater.

Symbols used in this manual

The following symbols are used in these instructions / appear on the appliance:

Certified by CSA.

Failure to observe this instruction may expose you or others to danger.
Failure to observe this instruction may lead to damage to the device.

Indicates live parts.
Failure to observe this instruction may lead to damage to the device or dan-
ger to you or others.

Please read the manual.

Hazardous materials and waste electrical and electronic equipment should 
be taken to a designated recycling point.

IMPORTANT SAFETY INSTRUCTIONS 

When using this electrical equipment, basic safety precautions should always be 

followed, including the following

.

READ AND FOLLOW ALL INSTRUCTIONS

All supply circuits must be disconnected before removing cover. Supply this ap-

pliance only from a grounded system. A wire connector marked “ ” is provided 

for wiring the appliance. Connect the connector to the grounding terminal of the 

electric service or supply panel with a continuous copper wire in accordance Ca-

nadian Electrical Code, Part I.

0.  Contents

Contents ��������������������������������������������������������������������������������������������2
Safety Instructions �����������������������������������������������������������������������������3
Mounting Instructions ������������������������������������������������������������������������6
Technical Specifications �������������������������������������������������������������������14
User Manual ������������������������������������������������������������������������������������15
Maintenance ������������������������������������������������������������������������������������18
Troubleshooting �������������������������������������������������������������������������������19
Warranty Conditions �������������������������������������������������������������������������20

Summary of Contents for marey PP4













Reviews: