751-3002 [AS-Interface Module 4IN 24V A/B]
•
9
Connectors
WAGO-I/O-SYSTEM 751
AS-Interface Components IP67
2.1.1.3 Connectors
2.1.1.3.1 AS-Interface Cable
The AS Interface cable is connected using piercing technology.
When assembling the upper part, contacts are pressed into the cable which is
located in the ground plate, making the electrical contact.
The functional earth contact is also made during assembly of the upper part.
2.1.1.3.2 Sensor Connectors
Sensor connections are 5-pole sockets for M12x1 round plugs.
When using angled connectors, the socket design provides a connecting angle
of 45° (top left or top right) for the connecting cable.
The following table shows the pin assignment of the sockets.
Tab. 2.1.1-1: Sensor Connectors
Sensor Connectors
Connector
Pin Function
IN 1/3
IN 2/4
1
Sensor supply L+
IN 1/3
---
2
Sensor signal (from IN 2/4 Pin 4)
IN 1/3
IN 2/4
3
Sensor supply L-
IN 1/3
IN 2/4
4
Sensor signal
3
4
2
1
5
3
4
2
1
5
IN 1/3
IN 2/4
Fig. 2.1.1-2: Sensor
Connector
gqxxx01x
IN 1/3
IN 2/4
5
Functional earth FE
Pin 5 of the sockets makes connection to functional earth. Four-pole plugs
without functional earth or 5-pole plugs with functional earth may be
connected.
Pin 2 of the IN 1 or the IN 3 socket is connected with Pin 4 of the IN 2 or IN 4
socket. This allows the connection of 2-channel sensors with the IN 1 or IN 3
socket. The IN 2 or IN 4 socket will then remain unconnected.
Warning
The inputs are DC coupled with the AS-Interface voltage. They shall not be
supplied with an external supply voltage!
Warning
Unused sensor connections must be sealed with protective caps!
