WAGO I/O System Compact
Mounting 73
751-9301 Compact Controller 100
Manual
Version 1.1.0, valid from FW Version 03.08.07(20)
6.4.2.2 Removing the Female Connector
WAGO recommends using a
picoMAX
®
unlocking tool (referred to in the following
text as the “unlocking tool”). Further information on the unlocking tool is provided
in the Section “Accessories” > “Tools”.
Figure 10: Removing the Female Connector without Wiring (Application Example)
Figure 11: Removing the Female Connector with Wiring (Application Example)
Table 43: Legend for Figures “Removing the Female Connector …”
Position Description
1
Male locking latch
2
Protruding rim of the female connector
3
Unlocking tool
6.4.2.2.1 Removing the Female Connector without Wiring
Proceed as follows to remove the female connector with the unlocking tool:
1.
Place the unlocking tool (3) onto the locking latch (1).
2.
Insert the unlocking tool fully.
Wedge opens locking latches (also see the figure “Removing the female
connector with wiring”).
3.
Grip underneath the protruding rim of the female connector (2).
4.
Pull out the female connector.
