56
Parameterizing
WAGO-SPEEDWAY 767
767-5801/000-800 8DIO 24V DC 0.5A IF (8xM8)
Manual
Version 1.1.0
Pos: 30.6 /Serie 767 (WAGO-SPEED WAY)/Par ametrieren/I/O-M odule/Parametri erung 767- xxxx Di agnoseübersicht_1 @ 14\mod_1360836957753_21.docx @ 111870 @ 2 @ 1
7.2
Diagnostic Overview
The currently pending diagnostics existing on the module are displayed here. In
this view of the DTM, you can enable simulation of the diagnostics, as well as
disable transmission of the diagnostics. When disabling transmission, make sure
that the display behavior of each LED changes that indicates the specific
diagnostics (section "Diagnostics" > "LED Signaling"). The diagnostic overview
is only available in online mode.
Figure 19: Example of the diagnostic overview of a module (information may differ from the
actual module)
Pos: 30.7 /Serie 767 (WAGO-SPEED WAY)/Par ametrieren/I/O-M odule/Parametri erung 767- xxxx Di agnoseübersicht_2 @ 7\mod_1265811272140_21.docx @ 50279 @ @ 1
Table 29: Diagnostics setup
Parameter
Description
Insert in PI
By unselecting the checkbox, you specifically suppress evaluation and
transmission of individual diagnostics. Doing so has no effect on the
size of the process image. Even if a diagnostics has occurred, the
diagnostic value "0" (no error) is transmitted to the higher-level
controller.
Simulation
If you have selected the "Insert in PI" checkbox, the "Simulation"
parameter is released. You can select the diagnostics you want to
simulate. Click the
[Write]
button to transfer the simulated values to the
module.
Status
Displays whether there is a diagnostics:
X mark: There is a diagnostic message.
Check mark: There is no diagnostic message.
Pos: 30.8 /Dokumentation allgemei n/Glieder ungselemente/---Seitenwechsel--- @ 3\mod_1221108045078_0.docx @ 21810 @ @ 1
