WAGO-I/O-SYSTEM 758
Configuration
35
758-915
Bluetooth
®
ETHERNET Gateway
Manual
Version 1.1.0, applicable from FW/HW Version 01/01
7.3
Configuration using the Web-based Management
System (WBM)
A Web-based Management System (WBM) is available on an integrated Web
server for configuring the WEG.
You can go the WBM by entering the IP address of the device in the browser
URL line.
Device configuration is password protected. If you have forgotten the IP address
or password you can reset the device to its factory default settings.
On initial commissioning, the device uses the static IP address and the default
settings password (see Section “Default Settings”). You may have to modify the
IP configuration of the PC from which you are accessing the WBM before a link
can be set up.
7.3.1
Accessing the Web-based Management System
1.
To open the WBM, launch a Web browser (e.g., Microsoft Internet Explorer
or Mozilla Firefox).
2.
Enter the IP address of the WEG on the URL line and confirm by pressing
[Enter]
.
For WBM access; check the IP/firewall settings and the connection!
If you are not granted access to the WBM check the IP configuration for the PC
from which you wish to access the WBM and the settings for the firewalls being
used. Ensure that the WEG is properly connected and ready for operation and that
the specified IP address is correct. Should you still not be able to set up a
connection to the WBM after ruling out any error at the PC, or if you have
forgotten the IP address of the WEG, reset the device to its factory default
settings.
When access has been made to the WBM the WEG will display an overview page
showing status information and operating elements for changing the device
configuration (see figure below).
Before taking any further steps you should log on to the system using a valid
password:
3.
Enter your password in the field
System Overview > Password
.
4.
Send the password by clicking on
[Login]
.
