WAGO-I/O-SYSTEM 758
Configuration
31
758-915
Bluetooth
®
ETHERNET Gateway
Manual
Version 1.1.0, applicable from FW/HW Version 01/01
Table 15: Autoconfiguration Procedures
Press
button Autoconfiguration Procedures
LED A B C D
5 x
4 Initiate automatic configuration via
Bluetooth
®
,
WEG-WEG bridge
The WEG automatically sets up a link to a different WEG
that is in the configuration mode “Wait for automatic
configuration” (LED C) and then configures that WEG.
A+C
6 x
6 Initiate automatic configuration via
Bluetooth
®
,
WEG-WEG bridge with PROFINET-/PROFISAFE
optimization
The WEG automatically sets up a link to a different WEG
that is in the configuration mode “Wait for automatic
configuration” (LED C) and then configures that WEG.
B+C
On configuration using the Mode membrane button, only those parameters
required for the particular autoconfiguration will be overwritten.
You can initially make changes via the Web-based Management System and then,
for example, inhibit WLAN channels that are not to be used (“Channel skipping”).
These changes also remain effective after one of the automatic configurations 3, 4,
5 or 6.
Autoconfiguration procedures 1 to 3 always become effective; procedures 2 and 3
change the device configuration immediately.
Autoconfiguration procedures 4 to 6 only change the device configuration when a
radio link has been successfully established. If the WEG loses power before the
autoconfiguration has been completed, or if no other WEG can be contacted via
the radio link within 5 minutes for automatic configuration, the device will retain
its previous configuration settings when it is restarted.
The following settings are overwritten in the course of the various
autoconfiguration procedures:
