WAGNER WallPerfect PowerRoll, Operating Instructions Manual

Page: 29 / 62

GB
21
PowerRoll System
i
Residual paint might remain int he hose. This is normal and does not
influence any future work negatively.
After cleaning, pump all the water out of the device and hose.
With pumps filled with water, at temperatures below 0°C there is a risk of frost
damage.
Remove the roller frame from the handle. 12)
Wipe these parts very thoroughly. Especially the areas marked in Fig. 17 must be 13)
completely freed of paint and lubricated, in order to guarantee perfect functioning.
Do not immerse the handle in water during cleaning.
If you have been using the FineLiner, clean the side-frame and brush under running 14)
water.
Also wipe the other parts of the device clean if necessary. 15)
reassembling the paint roller and roller frame
1) Insert the cover cap (Fig. 18, 1) into the paint roll.
2) Hold the cover cap firmly and press the inner roll into the paint roll (Fig. 18, 2) from
the other side.
Push the paint roll onto the roller frame until it audibly engages. 3)
Storage
Attention! risk of damage due to freezing
water. Store the device in a frost-free place
only once it has been completely emptied.
Apply a thin coat of sliding grease at the marked points for
preservation. (Fig. 19)
Spare Parts
Spare parts list (fig. 20)
Item Designation Order no.
1 Roller frame PowerRoll (incl pos. 2) 2325 740
2 Sealing set 2325 742
3 Inner roll and cover cap 2325 720
4 Paint roll (nap height 12mm, for smooth and lightly
textured surfaces)
Paint roll (nap height 20mm, for lightly textured and
rough surfaces)
0998 230
0245 717