27
VERSION 05/2019
ORDER NUMBER DOC2326960
PEM-X1 CG
Prerequisites for perfect grounding and coating of a work piece are:
– clean suspension of the work piece to be coated,
– the grounding resistance of the work piece must not exceed 1 M
(resistance to ground measured at 500 V or 1000 V).
Sparks between conveyor, conveyor hooks (hangers) and work piece can occur
if electric contact points between conveyor, conveyor hooks (hangers) and work
piece are not sufficiently cleaned and therefore the work pieces are not sufficiently
grounded! These sparks can cause heavy radio frequency interference (EMC).
6.6.1 GROUNDING THE POWDER COATING SYSTEM
P_01120
1
2
3
6
7
5
4
1 Only use mains cables with grounding strand!
2 Connect the control unit's grounding cable with the signal ground!
3 Connect grounding cable to an uncoated metal part of the booth!
4 Remove all paint from hooks and other hanger parts!
5 Wear electrostatically conductive gloves!
6 Wear electrostatically conductive footwear!
7 The floor must be electrostatically conductive!
6.7
SAFETY CHECKS
A skilled person must check to ensure that the device is in a reliable state after it is assembled
and commissioned.
This includes:
– Carry out safety checks in accordance with Chapter
.
