GB
LIMA
5
INSTALLATION
Choose a site for installation with as much irradiation as possible. Do not place the
LIMA in the shade of trees, bushes or buildings, as this will greatly reduce the degree of
efficiency of the LIMA.
PERFORMANCE
The performance of your LIMA depends on the time of year. LIMA is ready for
operation longer in summer than in winter.
How long LIMA shines at night depends on how long LIMA was exposed to direct solar
radiation during the day. For example, when the sky is overcast, less solar energy is
available to load the rechargeable battery. During the following night, the duration of
emission of light of LIMA is therefore shorter.
The duration of emission of light is strongly limited on winter days due to lower exposure
to solar radiation.
NOTE:
Clean the solar module regularly with a damp towel to guarantee
optimum performance of the solar collectors. Do not use any
solvents for cleaning. Do not put any pressure on the solar module
during cleaning.
FAILURE CORRECTION
If LIMA should fail to function despite observance of all instructions, please proceed as
described in the following steps :
1) Turn the selector switch several times to the positions „OFF“ and „ON“.
햵
2) It may occur that your LIMA is ready for operation but it is covered by
another source of light. In this case, relocate the solar station.
3) Ensure that your LIMA does not stand in the shade during the day.
4) Check the rechargeable battery for corrosion.
REMOVING / CHANGING THE RECHARGEABLE BATTERY (Bild 4 - 6)
●
Manually turn the solar module-counter-clockwise in order to seperate it from the
lamp unit
햶
.
●
Lay the solar modul face down.
●
Remove the rechargeable battery to re-load it and/or exchange it
햷
.
Re-assembly is accordingly conducted in the reverse order.
ATTENTION: 1) When removing/replacing the rechargeable battery, the
selector switch must be in position „OFF“!
햵
2)
Use Original WAGNER rechargeable batteries only.
3) When inserting batteries, make sure the polarity is correct (+/-)
