48
SuperFinish 23 Pro Select
EN
REPAIRS AT THE UNIT
10.5
REMEDY IN CASE OF FAULTS
TYPE OF MALFUNCTION WHAT ELSE?
POSSIBLE CAUSE
MEASURES FOR ELIMINATING THE MALFUNCTION
Unit does not start
The device does
not start after it has
been plugged in and
switched on.
No voltage applied
Check voltage supply
Unit fuse has triggered
Let the motor cool down
Capacitor in terminal box
burned out
Replace capacitor
Unit does not suck in
Air bubbles do not exit
at the return hose
Inlet/outlet valve clogged
/ worn
Remove the valves and clean then (-> refer to
Section Pkt.10.1/10.2) / replace worn parts
Pressure control valve
turned down completely
Turn the pressure control valve to the right un-
til the stop is reached
Air bubbles exit from
the return hose
Unit is sucking in outside
air
Check if Suction system is properly tightened
Check if red inlet is installed in the inlet valve
housing (-> see 4.1)
Unit does not gener-
ate pressure
Unit has sucked in
Air in the oil circuit
(Possible reasons: long
time not used, replace-
ment of diaphragm or
hydraulic oil change
Bleed the oil circuit in the unit by turning the
pressure control valve completely to the left
(until overturning) and let it run approx. 2 – 3
min. Then turn the pressure control valve to
the right and set the spraying pressure (repeat
process several times, if necessary).
Unit reached pres-
sure, but the pressure
collapses, also at the
pressure gauge, during
spraying.
Suction filter clogged
Check the suction filter. If necessary, clean/
replace
Paint cannot be worked in
this state. Due to its prop-
erties the paint clogs the
valves (inlet valve) and the
delivery rate is too low.
Dilute the paint
Unit reached pressure,
but the pressure col-
lapses during spraying.
pressure gage still
shows high pressure
Clogged filter do not let
enough paint pass
Check/clean the (high-pressure filter) gun filter
Tip clogged
Clean the tip
Unit does not generate
the max. pressure pos-
sible. Paint neverthe-
less exits at the return
hose.
Relief valve defective
Please contact Wager Customer Service
Summary of Contents for Brillux SUPER FINISH 23 PRO SELECT
Page 86: ...86 SuperFinish 23 Pro Select FR ...