Wagner Meters Orion 910, Instruction Manual

Page: 5 / 21

5 6
DOWN arrow buttons to set the correct
species setting for the wood species you
wish to measure (refer
to your Species Settings
Booklet to find the correct
setting). Finally, press
the ON/HOLD button to
place the meter back in
the Standard Measurement
mode.
NOTE: If you cannot find
the correct setting for the wood species
or material you wish to measure, go
to www.wagnerspecies.com where you
can access Wagner’s extensive Species
Database. If you still cannot find the
correct setting, contact a Wagner Meters
expert at 844-689-0660.
Grasping the meter on the sides, begin
taking measurements on the face of the
wood pieces by pressing down firmly,
making sure the rectangular sensor plate area
on the back side of the meter is pressing
firmly on the wood surface and completely
covered by the wood. Minimum wood
With your Orion® 910
turned OFF, press and
release the ON/HOLD
button. Meter will turn
on and briefly display the
model number, followed by the firmware
revision number. If this is the first time
you are using your new Orion® 910,
immediately after the revision number is
displayed, the meter display should revert
to Standard Measurement mode, with the
display showing 0.0% when the meter is held
in the air. If meter display does not display
0.0%, then refer to page 15 regarding the
SPECIES/MATERIAL button.
Next, press the SPECIES/
MATERIAL button once,
and the current species
setting (calibrated to
specific gravity) will
appear. The factory default displayed will
be 0.50 for a new meter. Use the UP or
QUICK START
BASIC USE FOR SOLID WOOD