Wagner Meters Orion 910, Instruction Manual

Page: 10 / 21

15 16
measure, go to www.wagnerspecies.com.
If you still cannot find the correct setting,
contact Wagner at 844-689-0660.
NEXT, once the meter is turned on, press
and release the SPECIES/MATERIAL
button until you are in the Species Setting
mode. Once you are there, the meter will
show the current setting with a decimal
(e.g., 0.62 or 1.00). If the meter is being
programmed for the first time, the default
setting of 0.50 will be displayed on
the screen.
While in this mode, pressing and releasing
either the UP or DOWN arrow buttons
will increase or decrease the setting of the
meter by .01 each time a button is pressed
and will update the display accordingly.
If the UP button is held
down for 0.7 seconds, the
setting will increase to the
next multiple of .10 (e.g., if
the setting is currently .36,
the setting will change to .40). Every 0.7
seconds thereafter that the button is held
3-digit number such as 0.50, etc.), you can
use the UP or DOWN arrows to program
the meter for the correct setting. If you
need to change modes, press and release
the SPECIES/MATERIAL button. If you
choose Relative Measurement (REL)
mode, press ON/HOLD to select. For
Calibration (CAL) mode, see page 24 for
full instructions.
Regardless of the mode you choose,
when the meter is turned OFF (or shuts
off automatically), and then the meter
is turned back ON, the meter will be in
the mode it was in when it previously
turned OFF.
How to Program a Species Setting
for Different Wood Species
FIRST, consult the Species Settings
Booklet and locate the correct setting that
corresponds to the type/species of wood
being measured.
NOTE: If you cannot find the correct setting
for the wood species or material you wish to