Solar e Power™ Cube 1500 Plus by Wagan Tech
®
En
g
lis
h
www.wagan.com
23
•
Check wiring or cables that are attached to the solar panels. Wire or cables may
become loose from turbulent weather conditions.
•
Store panels when not in use.
Fuse Replacement—DC Charging Adapter
The DC Charging Adapter comes equipped with one 15A quick blow fuse inside each plug end.
To replace a fuse, simply unscrew the head of the plug and remove the fuse. If blown, replace
with a 15 amp fuse of the same type and rating.
TROUBLESHOOTING GUIDE
Problem
Possible Cause
Solution
No AC output, Green
LED is not lit, Voltmeter
reads below 10 volts
Battery voltage too low
Reduce AC load and charge the Solar
e Power Cube battery
Excessive AC load
No AC output, no
displays lit
Battery Disconnect Switch
is OFF
Turn ON Switch
No AC output, 12 volt
outlets operate, USB
ports operate. Inverter
Switch is ON
Inverter is not working
Call Wagan Tech Support
12 volt DC outlets
switch on and off
DC Outlet is overloaded
Reduce DC load.
Television interference
Picture breaking up (static)
Place the Solar e Power Cube as far
as possible from the TV, the antenna
and the coaxial cable
TV station may be out of range
Static/noise interfer-
ence in audio system
Sound system has weak al-
ternating current shielding
Do not use Inverter with low quality
audio AC filtering system
Replace audio system with high qual-
ity noise filtering
Run time is less than
expected
Solar e Power Cube is not
fully charged
Charge using the AC Charging
Adapter.
Product power consumption
is higher than expected
Check the power or “wattage” rating
and compare with the tables in Bat-
tery Operating Times section of this
manual
Charging light is OFF
when AC Charging
Adapter is connected
No AC power at wall
socket
Ensure power is available at the wall
socket
